Lines Matching refs:be

17 be connected to a USB Host to extend it with additional functions like a serial
26 Creating a gadget means deciding what configurations there will be
41 In order for this to work configfs must be available, so CONFIGFS_FS must be
51 made available through configfs can be seen here:
62 For each gadget to be created its corresponding directory must be created:
82 In order to have a place to store them, a strings subdirectory must be created
87 Then the strings can be specified:
97 directories must be created:
101 where <name> can be any string which is legal in a filesystem and the
110 Each configuration also needs its strings, so a subdirectory must be created
115 Then the configuration string can be specified:
119 Some attributes can also be set for a configuration, e.g.:
127 directory must be created:
141 or read-write access. Where applicable they need to be written to as
151 function can be used in multiple configurations). This is achieved with
203 Such a gadget must be finally enabled so that the USB host can enumerate it.
204 In order to enable the gadget it must be bound to a UDC (USB Device Controller).
300 which can be read-only or read-write, depending on what they represent.
308 The filesystem view would be like this:
342 | data to be set  |                .
347 the directories in general can be named at will. A group can have
357 Writing to the attributes causes the information to be stored in