Lines Matching refs:IRQ

144 good default configuration to use. Please try to use same I/O, DMA and IRQ
159 	- "Device or resource busy". Probably the IRQ (or DMA) channel 
162 	- "I/O error". Almost certainly (99%) it's an IRQ or DMA conflict.
289 software selectable IRQ and DMA settings. If the (power on default) values
338 soft configuring their I/O, IRQ, DMA and shared memory resources.
359 work now. "Proper" means that I/O, IRQ and DMA settings are the same as in
644 configure the driver use I/O, IRQ and DMA settings
657 the driver to use I/O, IRQ and DMA settings which are known to work.
693 DOS based driver initializes the hardware to use known I/O, IRQ and DMA
869 Entering the I/O, IRQ and DMA config parameters
874 I/O address, IRQ and DMA numbers are asked. With some cards the program
886 Please refer manual of your card for valid I/O, IRQ and DMA numbers. Using
898 It's possible to configure these cards to use different I/O, IRQ and
902 it's the only choice. SB16 has software selectable IRQ and DMA channels but
905 if Linux has used different IRQ or DMA values.
948 	- If you use the same I/O, IRQ and DMA settings in Linux, the
996 for the I/O, IRQ and DMA numbers for the card. Use the same values than
1000 IRQ and DMA numbers for the daughter card. You have to use different I/O
1005 GUS MAX uses the same I/O address and IRQ settings than the original GUS
1082 Configuring ATP is little bit tricky since it uses so many I/O, IRQ and
1084 attempt to use the same IRQ or DMA channels twice.
1088 both the SB driver and the SB mode of ATP to use the same IRQ, DMA and I/O
1129 The configuration program asks one DMA channel and two interrupts. One IRQ
1130 and one DMA is used by the MSS codec. The second IRQ is required for the
1285 At least a card called (Pearl?) Hypersound 16 supports IRQ 15 but it doesn't
1397 loadlin.exe to boot Linux. If Linux is configured to use the same I/O, IRQ and