Lines Matching refs:with

1 	Guide to using M-Audio Audiophile USB with ALSA and Jack	v1.5
6 This document is a guide to using the M-Audio Audiophile USB (tm) device with 
82 parameter), or in an "advanced" mode with the device-specific parameter called 
127 If you're happy with the default Alsa driver mode and don't experience any 
128 issue with this mode, then you can skip the following chapter.
136 from the Ai interface sounds distorted (as if boosted with an excessive high
151 When initialized with "device_setup=0x00", the snd-usb-audio module has
162    - 16bits 48kHz mode with Di disabled
168    - 16bits 48kHz mode with Di enabled
190    - 24bits 48kHz mode with Di disabled
196    - 24bits 48kHz mode with Di enabled
218    - 16bits 48kHz mode with only the Do port enabled 
219    - AC3 with DTS passthru
220    - Caution with this setup the Do port is mapped to the pcm device hw:1,0
247    turn off the device, unprobe the snd-usb-audio module, then probe it again with
251    to  another mode (possibly with another sample-depth), please use also the following 
284    - it is set only for Digital output with DTS/AC3
334    - MIDI interface compliant with the MIDIMAN quirk 
362  * if DTS is chosen, only Interface 2 with AltSet nb.6 must be
380 This section deals with support of the Audiophile USB device in Jack.
382 There are 2 main potential issues when using Jackd with the device:
392 with jackd version 0.103.0 it's almost ok (just a small bug is affecting 
397 You can run jackd with the following command for playback with Ao and
398 record with Ai:
406 For instance here is one way to run Jack with 2 playback channels on Ao and 2 
426 If you want to get Ai+Di and/or Ao+Do support with Jack, you would need to
439 * start jackd with this device
441 I had no success in testing this for now, if you have any success with this kind