Lines Matching refs:board
30 - 2 ports multiport board
37 - 4 ports multiport board
51 - 8 ports multiport board
112 family multiport board.
114 ISA board
119 Please make sure the JP1 is open after the ISA board is set properly.
121 PCI/UPCI board
129 Each port within the same multiport board shares the same IRQ. Up to
170 Naming convention for each Smartio/Industio multiport board is
174 1st board ttyM0 - ttyM7 cum0 - cum7
175 2nd board ttyM8 - ttyM15 cum8 - cum15
176 3rd board ttyM16 - ttyM23 cum16 - cum23
177 4th board ttyM24 - ttym31 cum24 - cum31
188 in the driver. After all specified ISA board activated, PCI board
190 Therefore the board number is sorted by the CAP address of ISA boards.
209 add/delete one MOXA board.
219 to specify the total installed MOXA board number. Default major
254 if "mxser" is activated. If the MOXA board is ISA board, the
268 But if you use ISA board, please modify the "modprobe ..." command
289 board while activating "mxser.o". The format for parameters are
294 | | | +- 4th ISA board
295 | | +------ 3rd ISA board
296 | +------------ 2nd ISA board
297 +------------------- 1st ISA board
319 In module mode, the CAP address for ISA board is given by
334 0x280 and 0x180 as 1st and 2nd board. Just to change
436 board found by driver in the system.
487 Error msg: More than 4 Moxa Smartio/Industio family boards found. Fifth board
490 To avoid this problem, please unplug fifth and after board, because Moxa
497 free IRQ and simply change another free IRQ for Moxa board.
501 Each port within the same multiport board shares the same IRQ. Please set
502 one IRQ (IRQ doesn't equal to zero) for one Moxa board.
504 Error msg: No interrupt vector be set for Moxa ISA board(CAP=xxx).
506 Moxa ISA board needs an interrupt vector.Please refer to user's manual