Lines Matching refs:you

40 module parameters (chapter 5) are ignored! However, you can change settings
55 If you got any recent kernel with this driver and document included in
56 linux/drivers/scsi, you basically have to do nothing special to use this
57 driver. Of course you have to choose to compile SCSI support and DC390(T)
63  If you got an old kernel (pre 2.1.127, pre 2.0.37p1) with an old version of
68  If you want to do it manually, you should copy the files (dc390.h,
74  The patches are against 2.1.125, so you might have to manually resolve
78  be passed to the driver, update the Documentation and finally offer you the
80  (By selecting "Omit support for non DC390" you basically disable the
84 If you got a very old kernel without the tmscsim driver (pre 2.0.31)
85 I recommend upgrading your kernel. However, if you don't want to, please
91 precautions. In an ideal world you would have a full backup of your disks.
100 * make sure you are able to boot Linux (e.g. from floppy disk using InitRD)
140 for you.)
188 If you want to change a setting, you can do that by writing to
189 /proc/scsi/tmscsim/?. Basically you have to imitate the output of driver.
201     Note that you can only change MaxID, MaxLUN, AdapterID, SelTimeOut,
203     unless you want to see what happens, if the driver hangs.
206     must match the ID and LUN given. If you give "-" as parameter, it is
208     You can use "y" or "n" instead of "Yes" and "No" if you want to.
231     This is only used for debugging when you meet problems. The parameter of
242     Note that you will meet problems when you REMOVE a device's DCB with the
245     remove it (scsi remove-single-device) and you really need a few bytes of
247     The ADD command allows you to configure a device before you tell the
258 But you may want to override the settings prior to being able to change the
260 If you do have another AM53C974 based adapter, that's even the only
261 possibility to adjust settings before you are able to write to the
262 /proc/scsi/tmscsim/? pseudo-file, e.g. if you want to use another 
265 For this purpose, you can pass options to the driver before it is initialised
304   you want to enable all values, e.g., you would use 31(0x1f). Default is 31.
334 As you can see, you don't need to specify all of the six params.
335 If you want values to be ignored (i.e. the EEprom settings or the defaults
336 will be used), you may pass -2 (not 0!) at the corresponding position.
340 allows it. If you meet problems, you can use tmscsim=-1 which is a shortcut
382   partition table and used a H/S = 64/32 or 255/63 translation. So if you
388   Try to disable DsCn, if you meet this problem. Please contact me for
394 Whenever you have problems with the driver, you are invited to ask the
397 If you find something, which you believe to be a bug, please report it to me. 
405 I will ask you for some more details and probably I will also ask you to
409 AM53C974, the logging might produce log output again, and you might end
433  This driver is free software; you can redistribute it and/or modify
436  If you want to use any later version of the GNU GPL, you will probably
437  be allowed to, but you have to ask me and Tekram <erich@tekram.com.tw>