Lines Matching refs:settings

40 module parameters (chapter 5) are ignored! However, you can change settings
142 the attached devices and their settings.
161 Note that the settings MaxID and MaxLUN are not zero- but one-based, which
196 (1) Change driver settings: 
205 (2) Change device settings: You write a config line to the driver. The Nr
211     with the given settings (Sync, TagQ).
252 settings to see if everything changed as requested.
257 With the DC390, the driver reads its EEPROM settings and tries to use them.
258 But you may want to override the settings prior to being able to change the
261 possibility to adjust settings before you are able to write to the
269  settings of the DC390 with cmd line parameters. This has changed since
278 DC390 EEPROM, the settings are given in a DC390 BIOS' way.
335 If you want values to be ignored (i.e. the EEprom settings or the defaults
365   cause problems, cause these settings are mostly per Target and not per LUN