Lines Matching refs:commands

21 8.  Control commands
24       8.3  Set maximum number of concurrent tagged commands
31 10. Boot setup commands
34              10.2.1  Default number of tagged commands
156 Control commands:      write operations to the proc SCSI file system
160 Boot setup commands
214 me using tagged commands are the following:
228 maximum number of queued commands up to 32. The Symbios Setup only allows 
231 The maximum number of simultaneous tagged commands queued to a device
236 This driver supports up to 255 commands per device, and but using more than 
239 accept more than 64 simultaneous commands. So, using more than 64 queued 
240 commands is probably just resource wasting.
248 will set tagged commands queue depths as follow:
261   to the actual number of disconnected commands. 
263 - Every 200 successfully completed SCSI commands, if allowed by the
264   current limit, the maximum number of queueable commands is incremented.
268 number of commands used and their status, as well as its decision on the 
293 8. Control commands
295 Control commands can be sent to the driver with write operations to
302 Using "all" for "<target>" parameter with the commands below will
305 Available commands:
330 8.3 Set maximum number of concurrent tagged commands
335     tags:      number of concurrent tagged commands
413     Entering 0 defaults to tagged commands not being used.
416 Maximum number of queued commands     (default answer: 32)
417     This option allows you to specify the maximum number of tagged commands 
425 10. Boot setup commands
429 Setup commands can be passed to the driver either at boot time or as
436 - enable tagged commands, up to 4 tagged commands queued.
447 10.2.1  Default number of tagged commands
450   #tags will be truncated to the max queued commands configuration parameter.
590 - tagged commands disabled
607 tagged commands queuing.