Lines Matching refs:boot

47       10.4 SCSI BUS checking boot option
244 depths from the boot command-line. For example:
274 1st method: boot your system using 'sym53c8xx=verb:0' option.
276             corresponding to your controller after boot-up.
378     th driver verbose level after boot-up.
404 this feature after boot-up only for devices that support it safely.
414     This parameter can be specified from the boot command line.
422     will use at boot time for synchronous data transfer negotiations.
429 Setup commands can be passed to the driver either at boot time or as
432 Example of boot setup command under lilo prompt:
489     any value suggested as boot option. Otherwise, if a suggested value 
536         0x08   ignore NVRAM "Scan at boot time" parameter for all devices
557 or on the kernel boot line as:
560 10.4 SCSI BUS checking boot option.
692 The Symbios NVRAM also holds data on the boot order of host adaptors in a
714     Verbose boot messages              N                   Y
720     Scan at boot time                  N                   Y
722 In order to speed up the system boot, for each device configured without 
723 the "scan at boot time" option, the driver forces an error on the 
803         boot configuration -  56 bytes (4x14 bytes)
833                        0x00000100 verbose boot msgs
841 boot configuration
843 boot order set by order of the devices in this table
851        |  |  |  |     |         --0x01 init/scan at boot time
895     0x00000010 - scan at boot time
1000                                             as BIOS dev    1 - boot device
1007                | | |              --------- boot delay     0 -   3 sec