Lines Matching refs:when
22 These parameters can be programmed to come into effect either when a
51 parameters are reset when a new tape is loaded).
75 be a multiple of the block size. This is not required when reading but
83 By default the driver writes one filemark when the device is closed after
125 backward compatible with the numbering used when the minor number was
178 movement such as when rewind on close tape devices are used.
195 Note: The in_flight value is incremented when an I/O starts the I/O
204 when reading them back via sysfs they may be in the process of being
205 updated when starting an I/O or when it is completed.
208 updated and decremented when an I/O completes after updating statistics.
209 The value of in_flight is 0 when there are no I/Os outstanding that are
216 defining the value of the symbol ST_SYSV. The semantics differ when a
248 cause a surprise when moving from 2.4. There small writes (e.g., tar without
307 are configurable when the driver is loaded as a module. The keywords are:
325 to use the same keyword used when loading as module but prepended
331 versions is supported. The same keywords can be used as when loading
450 MT_ST_NOWAIT_EOF enables immediate filemark mode (i.e. when
454 MT_ST_SILI enables setting the SILI bit in SCSI commands when
455 reading in variable block mode to enhance performance when
500 more bits in the extended sense data when the drive needs
523 block is -1 when it can't be determined (e.g., after MTBSF).