Lines Matching refs:driver

9 cache and board LRAM. A CDB is a single SCSI command. The driver
11 adapter detected. The number of CDBs used by the driver can be
62 1. ADVANSYS_ASSERT - Enable driver assertions (Def: Enabled)
65    driver. If an assertion fails a message will be displayed to
68    responsible for the driver. Assertion statements may proactively
69    detect problems with the driver and facilitate fixing these
71    execution of the driver.
73 2. ADVANSYS_DEBUG - Enable driver debugging (Def: Disabled)
75    Enabling this option adds tracing functions to the driver and the
76    ability to set a driver tracing level at boot time.  This option is
77    very useful for debugging the driver, but it will add to the size
78    of the driver execution image and add overhead to the execution of
79    the driver.
85    If the driver is loaded at boot time and the LILO Driver Option
95    If the driver is built as a loadable module this variable can be
96    defined when the driver is loaded. The following insmod command
137    through /proc to the driver. The information is useful for
138    monitoring driver and device performance. It will add to the
139    size of the driver execution image and add minor overhead to
140    the execution of the driver.
161 the AdvanSys Driver to Linux' section (B.4.) above, the driver will
180 the driver, e.g.
185 I/O Port may be added to specify the driver debug level. Refer to
191 Bob Frey <bfrey@turbolinux.com.cn> wrote the AdvanSys SCSI driver
193 and help maintain the driver.
203 AdvanSys driver in the Caldera releases.
207 driver work with a SCSI-1 disk.
210 support in the 3.1A driver.
213 suggestions to improve the driver and done a lot of testing.
226 the 3.2M driver.
241 driver development for ConnectCom (Version > 3.3F).