Lines Matching refs:target

29 an aggregated target value.  The aggregated target value is updated with
31 aggregated target value is simply the max or min of the request values held
33 Note: the aggregated target value is implemented as an atomic variable so that
41 target value.  Upon change to this list the new target is recomputed and any
42 registered notifiers are called only if the target value is now different.
47 Will update the list element pointed to by the handle with the new target value
48 and recompute the new aggregated target, calling the notification tree if the
49 target is changed.
52 Will remove the element.  After removal it will update the aggregate target and
53 call the notification tree if the target was changed as a result of removing
76 To register the default pm_qos target for the specific parameter, the process
82 To change the requested target value the process needs to write an s32 value to
87 To remove the user mode request for a target value simply close the device
98 The target values of resume latency and active state latency tolerance are
104 Note: The aggregated target values are implemented in such a way that reading
112 target value.  Upon change to this list the new target is recomputed and any
113 registered notifiers are called only if the target value is now different.
118 Will update the list element pointed to by the handle with the new target value
119 and recompute the new aggregated target, calling the notification trees if the
120 target is changed.
123 Will remove the element.  After removal it will update the aggregate target and
124 call the notification trees if the target was changed as a result of removing
194 certain protocol requirements or target frame or sample rates etc.