Lines Matching refs:or

63 IEEE 802.3 standards and support half or full-duplex operation in ISA bus 
65 in 16-bit ISA or EISA bus expansion slots and are available in 
66 10BaseT-only or 3-media configurations (10BaseT, 10Base2, and AUI for 10Base-5 
67 or fiber networks).  
79 v2.3.48 or greater kernel.  It can be compiled directly into the kernel
80 or loaded at run-time as a device driver module.
105    * IBM or IBM-compatible PC with:
106      * An 80386 or higher processor
108      * One available IRQ (5,10,11,or 12 for the CS8900, 3-7,9-15 for CS8920).
115 * LINUX kernel version 2.3.48 or higher
121    * GNU Toolkit (gcc and make) v2.6 or above (if compiling into kernel 
122      or a module)   
128 This program is free software; you can redistribute it and/or modify it under
133 ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or 
151 or for interface configuration when an EEPROM is not used. (CS8920-based 
172   Media Type:	       Autodetect (3-media cards) or 
209 provides a means to override the EEPROM's settings or for interface 
225 * dmasize=# (16 or 64) - DMA size 16K or 64K.  Default value is set to 16.
227    or media=bnc
228    or media=aui
229    or media=auto
231    or duplex=half
232    or duplex=auto
267    used with no EEPROM or command-line argument).
298 i) Cirrus recommend that the cs89x0 use the ISA DMA channels 5, 6 or
312 l) If during DMA operation you find erratic behavior or network data
322    'cs89x0_dma=N' where 'N' is the desired DMA channel number (5, 6 or 7).
328    or they may be placed in /etc/lilo.conf:
343 The cs89x0 driver can be compiled directly into the kernel or compiled into
389          from a DOS or command prompt session under Windows 95, Windows NT, 
390          OS/2, or other operating system.
439      hardware problem or due to a conflicts on the Boot PROM address
464 transmitted OK or in error.  The test can be terminated anytime by the user at 
494 a 10Base-2 or AUI connection.)
496 TX/RX LED: The yellow LED lights briefly each time the adapter transmits or 
502 An IO conflict occurs when two or more adapter use the same ISA resource (IO 
503 address, memory address or IRQ).  You can usually detect an IO conflict in one 
504 of four ways after installing and or configuring the CS8900/20-based adapter:
506     1.) The system does not boot properly (or at all).
511     3.) You cannot connect to the network or the driver will not load.
576     * IO Base, Memory Base, IO or memory mode enabled, IRQ, DMA channel
578     * Configured for media auto-detect or specific media type (which type).    
621 	cs89x0_media=rj45    or
622 	cs89x0_media=aui     or