Lines Matching refs:message

26       4.1.7 RAW socket returned message flags
29       4.2.2 Broadcast Manager message flags
31       4.2.4 Broadcast Manager message sequence transmission
33       4.2.6 Broadcast Manager multiplex message receive filter
233   creates an appropriate error message frame. Error messages frames can
237   by default. The format of the CAN error message frame is briefly
428   - The socket only receives valid data frames (=> no error message frames)
623   4.1.7 RAW socket returned message flags
640   such as message contents changes, packet length changes, and do time-out
644   created and modified at runtime; both the message content and the two
649   configuration message is defined. The basic BCM configuration message used
651   defined in the linux/can/bcm.h include. The BCM message consists of a
652   message header with a command ('opcode') followed by zero or more CAN frames.
690   distinguished by the unique can_id in each BCM message. However additional
733     RX_TIMEOUT: Cyclic message is detected to be absent (timer ival1 expired).
735     RX_CHANGED: BCM message with updated CAN frame (detected content change).
736       Sent on first message received or on receipt of revised CAN messages.
738   4.2.2 Broadcast Manager message flags
740   When sending a message to the broadcast manager the 'flags' element may
748     TX_COUNTEVT:        Create the message TX_EXPIRED when count expires
752     TX_CP_CAN_ID:       Copies the can_id from the message header to each
754       TX tasks the unique can_id from the message header may differ from the
764       RX_CHANGED message will be generated when the (cyclic) receive restarts.
779   4.2.4 Broadcast Manager message sequence transmission
783   element of the BCM message head. The defined number of CAN frames are added
784   as array to the TX_SETUP BCM configuration message.
806   ival1: Send RX_TIMEOUT when a received message is not received again within
810   ival2: Throttle the received message rate down to the value of ival2. This
815   4.2.6 Broadcast Manager multiplex message receive filter
817   To filter for content changes in multiplex message sequences an array of more
818   than one CAN frames can be passed in a RX_SETUP configuration message. The
824   filters) can be added as array to the TX_SETUP BCM configuration message.
889     rcvlist_err - list for error message frames masks
1012   netlink message types are defined and briefly described in
1158   by monitoring CAN error message frames and do a restart when
1163   Note that a restart will also create a CAN error message frame (see