Lines Matching refs:eth1

1194 must correspond with the name of the file, i.e., ifcfg-eth1 must have
1195 a device line of DEVICE=eth1.  The setting of the MASTER= line will
1296 devices (presumed to be eth0 and eth1), and have it persist across
1304 ip link set eth1 master bond0
1503 and eth1), and have it persist across reboots, edit the appropriate
1513 echo +eth1 > /sys/class/net/bond0/bonding/slaves
1547 active-backup mode, with eth0 and eth1 as slaves.
1551 	bond-slaves eth0 eth1
1554 	bond-primary eth0 eth1
1570 	bond-primary eth0 eth1
1572 auto eth1
1573 iface eth1 inet manual
1575 	bond-primary eth0 eth1
1590 bonded interface in which eth0 connects to a private network, while eth1
1592 traffic over eth0 first, using eth1 only as a fall back, while all other traffic
1619 Slave Interface: eth1
1627 # echo "eth1:2" > /sys/class/net/bond0/bonding/queue_id
1637 force all traffic bound to 192.168.1.100 to use eth1 in the bond as its output
1649 selection policy to be overridden, selecting instead qid 2, which maps to eth1.
1731         Slave Interface: eth1
1751 (MASTER) while eth0 and eth1 are slaves (SLAVE). Notice all slaves of
1770 eth1      Link encap:Ethernet  HWaddr 00:C0:F0:1F:37:B4
1948 device bond0 has two slaves, eth0 and eth1, and the routing table is
1954 10.0.0.0        0.0.0.0         255.255.0.0     U        40 0          0 eth1
1961 case, another host on network 10 would use eth0 or eth1 before bond0).
1991 alias eth1 tg3
1995 	If neither eth0 and eth1 are slaves to bond0, then when the
1999 when the e1000 driver loads, it will receive eth0 and eth1 for its
2057 eth1 are slaves of bond0 and the driver for eth0 is loaded before the
2065      interfaces.ifTable.ifEntry.ifDescr.3 = eth1
2082      interfaces.ifTable.ifEntry.ifDescr.4 = eth1
2166                          eth0 +-------+ eth1
2249      |          |eth1            port2|          | here somewhere
2276     |          |eth1   port2|          +------------------+ Host C |
2596 I/O Module #1; similarly, all eth1 ports are wired to I/O Module #2.
2620 modules 1 and 2.  In this configuration, the eth0 and eth1 ports of a
2626 switch.  By using PMs in I/O module #1 and #2, the eth0 and eth1