Lines Matching refs:ad

54 3.7 Configuring LACP for 802.3ad mode in a more secure way
161 "mode=802.3ad" and "mode=4" set the same mode.
188 	This parameter has effect only in 802.3ad mode and is available through
200 	This parameter has effect only in 802.3ad mode and is available through
205 	Specifies the 802.3ad aggregation selection logic to use.  The
228 		- Any slave's 802.3ad association state changes
239 	802.3ad aggregations when partial failure of the active aggregator
257 	This parameter has effect only in 802.3ad mode and is available through
499 	to transmit LACPDU packets in 802.3ad mode.  Possible values
536 	links are active before switchover. This option only affect 802.3ad
540 	802.3ad mode) whenever there is an active aggregator, regardless of the
594 	802.3ad or 4
596 		IEEE 802.3ad Dynamic link aggregation.  Creates
599 		aggregator according to the 802.3ad specification.
605 		policies may be 802.3ad compliant, particularly in
607 		section 43.2.4 of the 802.3ad standard.  Differing
616 		2. A switch that supports IEEE 802.3ad Dynamic link
620 		to enable 802.3ad mode.
837 	balance-xor, 802.3ad, and tlb modes.  Possible values are:
850 		This algorithm is 802.3ad compliant.
879 		This algorithm is 802.3ad compliant.
906 		This algorithm is not fully 802.3ad compliant.  A
913 		conversations.  Other implementations of 802.3ad may
1662 3.7 Configuring LACP for 802.3ad mode in a more secure way
1665 When using 802.3ad bonding mode, the Actor (host) and Partner (switch)
1789 	The 802.3ad mode requires that the switch have the appropriate
1790 ports configured as an 802.3ad aggregation.  The precise method used
1794 etherchannel is set to mode "lacp" to enable 802.3ad (instead of
2105 	For the balance-rr, balance-xor, broadcast, and 802.3ad modes,
2369 802.3ad: This mode can be a good choice for this type of network
2370 	topology.  The 802.3ad mode is an IEEE standard, so all peers
2371 	that implement 802.3ad should interoperate well.  The 802.3ad
2375 	available for 802.3ad).  The 802.3ad standard also mandates
2378 	packets.  The 802.3ad mode does have some drawbacks: the
2385 	Additionally, the linux bonding 802.3ad implementation
2390 	dependent upon the balancing policy of the peer's 8023.ad
2394 	Finally, the 802.3ad mode mandates the use of the MII monitor,
2403 	manner (not a simple XOR as in balance-xor or 802.3ad mode),
2408 	Unlike 802.3ad, interfaces may be of differing speeds, and no
2750 	In 802.3ad mode, it works with systems that support IEEE
2751 802.3ad Dynamic Link Aggregation.  Most managed and many unmanaged
2752 switches currently available support 802.3ad.