Lines Matching refs:MII

67 7.3	MII Monitor Operation
520 	Specifies the MII link monitoring frequency in milliseconds.
522 	inspected for link failures.  A value of zero disables MII
814 	Specifies whether or not miimon should use MII or ETHTOOL
816 	status. The MII or ETHTOOL ioctls are less efficient and
828 	MII / ETHTOOL ioctl method to determine the link state.
831 	0 will use the deprecated MII / ETHTOOL ioctls.  The default
1478 To enable MII monitoring on bond0 with a 1 second interval:
1480 	NOTE: If ARP monitoring is enabled, it will disabled when MII
1608 MII Status: up
1609 MII Polling Interval (ms): 0
1614 MII Status: up
1620 MII Status: up
1726         MII Status: up
1727         MII Polling Interval (ms): 1000
1732         MII Status: up
1736         MII Status: up
1865 monitoring a slave device's link state: the ARP monitor and the MII
1869 bonding driver itself, it is not possible to enable both ARP and MII
1913 7.3 MII Monitor Operation
1916 	The MII monitor monitors only the carrier state of the local
1919 querying the device's MII registers, or by making an ethtool query to
1923 then the MII monitor will rely on the driver for carrier state
1925 use_carrier parameter information, above, if the MII monitor fails to
1930 	If use_carrier is 0, then the MII monitor will first query the
1931 device's (via ioctl) MII registers and check the link state.  If that
1932 request fails (not just that it returns carrier down), then the MII
1935 does not support or had some error in processing both the MII register
1936 and ethtool requests), then the MII monitor will assume the link is
1968 interface basis), and is discarded.  The MII monitor is not affected
2039 fixed interval, but does not cache the MII register values (so the
2200 failures, then either the MII or ARP monitors should work.  For
2202 end, the MII monitor has no direct means to detect this.  The ARP
2394 	Finally, the 802.3ad mode mandates the use of the MII monitor,
2431 the MII monitor (which does not provide as high a level of end to end
2485 	Again, in actual practice, the MII monitor is most often used
2488 advantages over the MII monitor are mitigated by the volume of probes
2662 ports and the devices on the JS20 system itself.  The MII monitor is
2665 	When a passthrough module is in place, the MII monitor does
2824 You will also find a lot of information regarding Ethernet, NWay, MII,