Lines Matching refs:need

108 All you will need to do in order to install the driver is:
116 your current kernel, you will need to first copy arcnet.c over the one in
194 If you're using a loadable module, you need to use insmod to load it, and
234 If you have the chipset support built as a loadable module, then you need to 
249         you never know what you might need.
251         With AmiTCP (and possibly others), you may need to set the following
263         initialization.  In fact, if you use it on a 386+ you REALLY need
283 	ARCnet packets.  If you use ODI, you'll need to use the 'arc0'
285 	See the "Multiprotocol Support" section below if you need arc0e,
286 	you're completely insane, and/or you need to build some kind of
290 	SMC.  You need to use the 'arc0e' interface for this.  If you get
316 		Unless you have a specific need to use a different protocol,
350 ifconfig the arc0 device.  To actually use them, though, you need to also
351 ifconfig the other virtual devices you need.  There are a number of ways you
362    If you need only arc0, then the following commands should get you going:
368    If you need arc0e (and only arc0e), it's a little different:
379    Now things start getting confusing.  To even try it, you may need to be
423    Client, which means I need the arc0e device.  It needs to be able to talk