Lines Matching refs:duplex

25   3c509B (later revision of the ISA card; supports full-duplex)
27   3c589B (later revision of the 3c589; supports full-duplex)
42 needed except to enable full-duplex mode (see below). An example of the syntax
57 (2) Full-duplex mode
59 The v1.18c driver added support for the 3c509B's full-duplex capabilities.
60 In order to enable and successfully use full-duplex mode, three conditions
64 duplex operations. Currently, the only members of the 3c509 family that are
65 positively known to support full-duplex are the 3c509B (ISA bus) and 3c589B
67 full-duplex mode; these include the original 3c509 (no "B"), the original
72 AUI and 10base2 network cabling is physically incapable of full-duplex
76 itself full-duplex capable. This is almost certainly one of two things: a full-
77 duplex-capable  Ethernet switch (*not* a hub), or a full-duplex-capable NIC on
80 Full-duplex mode can be enabled using 'ethtool'.
82 /////Extremely important caution concerning full-duplex mode/////
83 Understand that the 3c509B's hardware's full-duplex support is much more
85 at the physical layer of the network it fully supports full-duplex operation,
88 auto-negotiate a full-duplex connection with its link partner under any
89 circumstances, no matter how it is initialized***. If the full-duplex mode
91 independently _forced_ into full-duplex mode as well; otherwise various nasty
94 negotiation and forcing the duplex mode of a network interface card or switch
102 0  transceiver type from EEPROM config (normally 10baseT); force half-duplex
106 4  10baseT (RJ-45 connector); force half-duplex mode
107 8  transceiver type and duplex mode taken from card's EEPROM config settings
108 12 10baseT (RJ-45 connector); force full-duplex mode
112 full-duplex mode, no matter what the card's detected EEPROM settings might be.
114 never automatically enable full-duplex mode in an existing installation;
198 host is incorrectly set to full duplex on a half duplex network. 
204 to full duplex (see above).