Lines Matching refs:be

29 Please note, however, that other components have to be set up on your
39 block/*/device/unload_heads in sysfs (here assumed to be mounted under
46 normal operation will be resumed. The maximal value accepted for a
48 -EOVERFLOW, but heads will be parked anyway and the timeout will be
58 of milliseconds remaining until normal operation will be resumed;
71 will be resumed.
74 milliseconds may raise expectations that cannot be satisfied in
77 that this will typically be within 500 milliseconds apparently has
81 confusion and should be discussed here. When a head park request has
83 controller port this device is attached to will be deferred. That is
84 to say, any other device that may be connected to the same port will
85 be affected too. The only exception is that a subsequent head unload
86 request to that other device will be executed immediately. Further
87 operations on that port will be deferred until the timeout specified
89 IDE) configurations are concerned, there can only be two devices
93 since this feature is supposed to be used on laptops and does not seem
94 to be very useful in any other environment, there will be mostly one
95 device per port. Even if the CD/DVD writer happens to be connected to
104 I/O operations on that drive (and the reset itself) will be delayed
110 detect these devices, so you won't be able to write to the
147 to develop an implementation of this feature that is fit to be merged