Lines Matching refs:Bit
189 12 69 Bit coded register:
190 Bit 0: 0 = Suppress response messages.
192 Bit 1: 0 = English response messages.
194 Bit 2: 0 = Echo off.
196 Bit 3 0 = DCD always on.
198 Bit 4 0 = CTS follows RTS
200 Bit 5 0 = return to command mode on DTR low.
204 Bit 6 0 = DSR always on.
206 Bit 7 0 = Cisco-PPP-flag-hack off (default).
208 13 0 Bit coded register:
209 Bit 0: 0 = Use delayed tty-send-algorithm
211 Bit 1: 0 = T.70 protocol (Only for BTX!) off
213 Bit 2: 0 = Don't hangup on DTR low.
215 Bit 3: 0 = Standard response messages
217 Bit 4: 0 = CALLER NUMBER before every RING.
219 Bit 5: 0 = T.70 extended protocol off
221 Bit 6: 0 = Special RUNG Message off
227 Bit 7: 0 = Don't show display messages from net
229 (S12 Bit 1 must be 0 too)
248 18 4 Bit coded register, Service-Octet-1 to accept,
250 Bit 0: Service 1 (audio) when set.
251 Bit 1: Service 5 (BTX) when set.
252 Bit 2: Service 7 (data) when set.
263 20 0 Bit coded register (readonly)
265 Bit mapping is the same as register 18
266 21 0 Bit coded register (readonly)
270 22 0 Bit coded register (readonly)
274 23 0 Bit coded register:
275 Bit 0: 0 = Add CPN to RING message off
277 Bit 1: 0 = Add CPN to FCON message off
279 Bit 2: 0 = Add CDN to RING/FCON message off