Lines Matching refs:X

2 X.25 support within isdn4linux
15 - If you connect to an X.25 neighbour not operated by yourself, ASK the
32 The ITU-T (former CCITT) X.25 network protocol layer has been implemented
34 useful to run X.25 on top of ISDN. If you want to try it, select
36    "CCITT X.25 Packet Layer"
40    "ISDN Support" and "X.25 PLP on Top of ISDN"
51 For testing, it is recommended that all isdn drivers and the X.25 PLP
60 X.25 on top of isdn might be useful with two different scenarios:
62 - You might want to access a public X.25 data network from your Linux box.
63   You can use i4l if you were physically connected to the X.25 switch
67   This corresponds to ITU-T recommendation X.31 Case A (circuit-mode
70   NOTE: X.31 also covers a Case B (access to PSPDN via virtual
74   with certain active isdn cards provided that the firmware supports X.31
77   possible to access D-channel X.31 with active AVM cards using the
83   same as ITU-T X.25.
88 To use the X.25 protocol on top of isdn, just create an isdn network
94 Once encap is set like this, the device can be used by the X.25 packet layer.
96 All the stuff needed for X.25 is implemented inside the isdn link
98 work with every existing HL driver. I was able to successfully open X.25
101 initiated when the upper (X.25 packet) layer requests the lapb datalink to
103 occurs, all existing X.25 connections on that link will be cleared
111 To operate in ISO-8208  X.25 DTE-DTE mode, use
115 To access an X.25 network switch via isdn (your linux box is the DTE), use
119 To mimic an X.25 network switch (DCE side of the connection), use
128 probably work if you access a public X.25 network as long as the
130 was successful to connect via isdn4linux to an X.25 switch using this
131 trick. At the switch side, a terminal adapter X.21 was used to connect
138 To test X.25 on top of isdn, you need to get
141   X.25 specific parameters.
143 - the x25-utils-2.X package from 
156 ifconfig the network interfaces up and add X.25-routes to them. Use
162 is needed to set up X.25 routes. I.e. 
166 will cause all x.25 connections to the destination X.25-address
169 There are currently no real X.25 applications available. However, for
171 and telnetd that uses X.25 sockets instead of tcp/ip sockets. You can
178 provide useful examples for setting up X.25 on top of isdn.
181 used to monitor X.25 packets received by the network interfaces.