Lines Matching refs:and

11     This program is free software; you can redistribute it and/or modify
38 6. Where to get additional info and help
44    PCI isdn cards Champ, Ergo and Metro. To enable support for this cards
45    enable ISDN support in the kernel config and support for HYSDN cards in
46    the active cards submenu. The driver may only be compiled and used if 
47    support for loadable modules and the process filesystem have been enabled.
52    handlers for various protocols like ppp and others as well as config info
53    and firmware may be fetched from Hypercopes WWW-Site www.hypercope.de.
59    active AVM cards and in fact uses the same module.
64    The module has no command line parameters and auto detects up to 10 cards
67    subdir need to be closed and all ethernet interfaces allocated by this 
75    capidrv.o after all modules using this driver (i.e. after hysdn and
82    card. One is called cardconfX and the other cardlogX, where X is the
89    actual state, available features and used resources.
90    The first 3 entries (id, bus and slot) are PCI info fields, the following
97    The following 3 fields show the hardware assignments for irq, iobase and the
99    The fields b-chans and fax-chans announce the available card resources of
107    3 -> card is booted and active
113    rebooted and an boot error occurs. 
119    and hyserver.pof for server cards.
143    get the cards and drivers log data. Card messages always start with the
152    to check and debug the driver itself:
163    0x00000010   Firmware load start and close are logged
170    0x00001000   Log the asynchronous scheduler actions (config and log)
171    0x00100000   Log all open and close actions to /proc/net/hysdn/card files
173    0x00010000   Log network interface init and deinit
175 6. Where to get additional info and help
178    the Hypercope support team (support@hypercope.de) and or the authors