Lines Matching refs:can

51      ISDN4Linux subsystem, so it can be used with any software which is able
67      can also be triggered manually using the modprobe(8) command, for example
74      can be used for that purpose, for example:
104      The device can be accessed from user space (eg. by the user space tools
114      You can also set a "default device" for the user space tools to use when
158      corresponding driver module is loaded, and can then be used with CAPI 2.0
179      after loading the module. It can then be used with ISDN4Linux
181      for setting up that subsystem. Otherwise you can use some HOWTOs like
202      You can use some configuration tool of your distribution to configure this
210      flag_time=0. You can do this e.g. by adding a line like
227      If you have installed the command line tool gigacontr, you can enter
230      You can switch back using
233      You can also put the driver directly into Unimodem mode when it's loaded,
246      ISDN calls. Their use can be enabled ("CID mode") or disabled ("Unimodem
258      the device is not in use (idle) can be selected by the user.
259      - If you want to receive incoming calls, you can use the default
267      You can also use the tty class parameter "cidmode" of the device to
277      Internal calls can be made by providing an internal extension number
307         Load the isdn module using the dialtimeout option. You can do this e.g.
340      You can control the amount of debugging information the driver produces by
349      The initial value can be set using the debug parameter when loading the
354      Generated debugging information can be found
362      If you can't solve problems with the driver on your own, feel free to