Lines Matching refs:you

8   This program is free software; you can redistribute it and/or modify it
22   Should you need to contact me, the author, you can do so either by e-mail
35   Should you encounter any problems while using the driver, or joysticks
51   For basic usage you just choose the right options in kernel config and
52 you should be set.
57 utilities is available at the abovementioned website. I suggest you download
63 you'll have to manually create these nodes in /dev:
86   For all joystick drivers to function, you'll need the userland interface
91   For gameport joysticks, you'll have to load the gameport driver as well;
95   And for serial port joysticks, you'll need the serial input line
101   In addition to that, you'll need the joystick driver module itself, most
102 usually you'll have an analog joystick:
121   And it should show a line with the joystick values, which update as you
126 is met, then it's all fine, and you can play the games. :)
134   For most joysticks you won't need any manual calibration, since the
136 some analog joysticks, that either do not use linear resistors, or if you
137 want better precision, you can use the jscal program
144   After calibrating the joystick you can verify if you like the new
145 calibration using the jstest command, and if you do, you then can save the
182 you'll need to specify the types either on the kernel command line or on the
205   In case your joystick doesn't fit in any of the above categories, you can
207 is not recommended unless you really know what are you doing. It's not
258 rear side of the joystick. However, moving it, you'll reset the joystick,
261 this time as a new center position. Use it if you want, but think first.
303   All these devices are autodetected, and you can even use any combination
322 allow connecting analog joysticks to them, you'll need to load the analog
342   If you have one of these, contact me.
385 using Y-cables, you can connect up to 8 analog joysticks to a single L4
386 card, 16 in case you have two in your system.
411 sound drivers themselves. Make sure you select gameport support in the
451 kernel, you also need to attach a serial port to it. to do that, run the
465 you bind it to some other function.
477 supported as well. To use the module, you need to run inputattach after you
495   To use it, you need to attach the serial port to the driver using the
515   To use it, you need to attach the serial port to the driver using the
522   In case you're using the device via the USB port, the inputattach command
543   There is quite a high probability that you run into some problems. For
551   Additionally you can do a test with the evtest utility: