Lines Matching refs:use

10 it will be true. So, use it at your own risk. The possible damages that can
36   All NES and SNES use the same synchronous serial protocol, clocked from
43 you'll use for NES, SNES gamepads and SNES mice.
47 for your pads, use either keyboard or joystick port, and make a pass-through
51   If you want to use the parallel port only, you can take the power is from
54 hand, if you are not planning to use anything else than NES / SNES on the
61 case, you'll need to use diodes (as a prevention of destroying your parallel
76 pins from pin 18 to pin 25. So use any pin of these you like for the ground.
106 also use 5 wires, but have more buttons. They will work as well, of course.
256   On a side note, if you have already built a different adapter for use with
263 want to use them on one parallel port together with NES/SNES/PSX pads. This is
271 if you want to use gamecon.c.
342 Multisystem joystick. However, since they don't use switches and use TTL
348 Multisystem joysticks. Set the driver to Multi2 mode, use the corresponding
369 to the Sega Master System pads. They use more buttons (3+1, 5+1, 6+1).  Use
397 Genesis 6 pads use, it needs one more select pin. Anyway, it is still
461   Should you want to use more than one of parallel ports at once, you can use
500   Should you want to use more than one of these joysticks/pads at once, you
501 can use db9.dev2 and db9.dev3 as additional command line parameters for two
515   Should you want to use more than one of these interfaces at once, you can
516 use turbografx.map2 and turbografx.map3 as additional command line parameters