Lines Matching refs:pwm
91 pwm[1-5] - this file stores PWM duty cycle or DC value (fan speed) in range:
94 pwm[1-5]_enable - this file controls mode of fan/temperature control:
96 * 1 Manual mode, write to pwm[0-5] any value 0-255
102 pwm[1-5]_mode - controls if output is PWM or DC level
109 pwm[1-5]_temp_sel Temperature source. Value is temperature sensor index.
111 pwm[1-5]_weight_temp_sel
119 pwm[1-5]_weight_duty_step
121 pwm[1-5]_weight_temp_step
124 to the current pwm value.
125 pwm[1-5]_weight_temp_step_base
128 pwm[1-5]_weight_temp_step_tol
136 pwm[1-5]_target_temp Target temperature, unit millidegree Celsius
138 pwm[1-5]_temp_tolerance
146 pwm[1-5]_start fan pwm start value (range 1 - 255), to start fan
148 pwm[1-5]_floor lowest fan pwm (range 0 - 255) if temperature is below
151 pwm[1-5]_step_up_time milliseconds before fan speed is increased
152 pwm[1-5]_step_down_time milliseconds before fan speed is decreased
153 pwm[1-5]_stop_time how many milliseconds must elapse to switch
173 controlled by setting the pwm and temperature attributes. When the temperature
176 points should be set to higher temperatures and higher pwm values to achieve
180 pwm[1-5]_auto_point[1-7]_pwm
181 pwm value to be set if temperature reaches matching
183 pwm[1-5]_auto_point[1-7]_temp
184 Temperature over which the matching pwm is enabled.
185 pwm[1-5]_temp_tolerance
187 pwm[1-5]_crit_temp_tolerance
191 pwm[1-5]_step_up_time milliseconds before fan speed is increased
192 pwm[1-5]_step_down_time milliseconds before fan speed is decreased