Lines Matching refs:can

57 outputs that can be used to control fan speed.
60 voltage can be measured without external resistors:
67 423 or socket 478 package. They can also measure temperature using a
75 This feature can also be disabled for manual control of the PWM's.
91 TACH signal from the fans. The ADM1027 can be configured to measure the
102 The ADM1027, ADT7463 and ADT7468 have a 10-bit ADC and can therefore
105 measurement. This offset can be used to zero out any errors due to traces
117 between 10 and 100 Hz, which can then be tuned separately.
126 of limit conditions and can automatically control the speeds of multiple
142 The LM85 can be jumpered for 3 different SMBus addresses. There are
151 that can be used to signal the chipset in case a limit is exceeded or the
152 temperature sensors fail. Individual sensor interrupts can be masked so
157 The ADT7463 and ADT7468 also have an optional THERM output/input which can
159 control dynamic Tmin feature can be enabled to keep the system temperature
181 pwm3 output control both fan3 and fan4. Each PWM can be individually
182 configured and assigned to a zone for its control value. Each PWM can be
220 The number of pulses-per-rev of the fans can be set, Tach monitoring
221 can be optimized for PWM operation, and an offset can be applied to