Lines Matching refs:can

9 First of all, a root filesystem must be made available. This can be done in
15       the target board can reach. This directory should then be NFS exported
16       such that the target board can read and write into it as root.
21       can be used. A complete image can be built using the mkfs.jffs2 or
30 boot loader) before it can be run. The kernel image (arch/frv/boot/Image) may
35       This is the simplest. RedBoot can store an image in the flash (see the
89       serial port <x> (which can be "0" or "1").
121       Authoritative information can be found in
152       The NFS version to use can also be specified. v2 and v3 are supported by
165       This can be used as an alternative to the "console=ttyS..." listed
175       SDRAM controller registers. That can be overridden with this