Lines Matching refs:linear
233 the recommended one to use for linear raid. But the latter is required for
244 Linear volume sets, i.e. linear raid, has been tested and works fine. Even
307 For a linear raid the table would look like this (note all values are in
313 0 1028161 linear /dev/hda1 0
314 1028161 3903762 linear /dev/hdb2 0
315 4931923 2103211 linear /dev/hdc1 0
384 Linear volume sets, i.e. linear raid, as well as stripe sets, i.e. raid level
386 the MD driver with NTFS volumes" especially if you want to use linear raid).
411 For linear raid, just change the raid-level above to "raid-level linear", for
441 an odd number of sectors. This is especially important for linear raid as all
447 So when using linear raid, make sure that all your partitions have an even
450 Even better is to simply use the Device-Mapper for linear raid and then you do