Lines Matching refs:all
58 is not implemented at all. Also, neither read nor write access to encrypted
113 sets contain insufficient characters to represent all
117 representing all Unicode characters.
131 access permissions. I.e. the mode on all files is by
134 Using a umask of zero will grant all permissions to
135 everyone, i.e. all files and directories will have mode
152 Further, note that irrespective of show_sys_files, all
157 case_sensitive=<BOOL> If case_sensitive is specified, treat all file names as
197 space is reserved for the MFT on the volume. If all
284 This would dump the LDM database found on /dev/hda which describes all of your
285 dynamic disks and all the volumes on them. At the bottom you will see the
286 VOLUME DEFINITIONS section which is all you really need. You may need to look
305 Assuming you know all your devices and their sizes things are easy.
307 For a linear raid the table would look like this (note all values are in
322 For a raid level 0 the table would look like this (note all values are in
336 this (note all values are in 512-byte sectors):
352 to the "Target Device" or if you specified multiple target devices to all of
362 If it all worked, you will now have the device /dev/device-mapper/myvolume1
426 Once the raidtab is setup, run for example raid0run -a to start all devices or
441 an odd number of sectors. This is especially important for linear raid as all
447 So when using linear raid, make sure that all your partitions have an even