Lines Matching refs:be

41 The filesystem should be enabled by turning on the kernel configuration
48 Additionally, the following can be turned on to aid debugging:
50 	CONFIG_AF_RXRPC_DEBUG	- Permit AF_RXRPC debugging to be enabled
51 	CONFIG_AFS_DEBUG	- Permit AFS debugging to be enabled
53 They permit the debugging messages to be turned on dynamically by manipulating
64 When inserting the driver modules the root cell must be specified along with a
72 RxRPC remote operation protocol and may also be accessed from userspace.  See:
79 Once the module has been loaded, more modules can be added by the following
87 Filesystems can be mounted anywhere by commands similar to the following:
98 The name of the volume can be suffixes with ".backup" or ".readonly" to
102 named volume will be looked up in the cell specified during modprobe.
104 Additional cells can be added through /proc (see later section).
115 automatically cause the target volume to be mounted (if possible) on that site.
117 Automatically mounted filesystems will be automatically unmounted approximately
118 twenty minutes after they were last used.  Alternatively they can be unmounted
121 Manually unmounting an AFS volume will cause any idle submounts upon it to be
122 culled first.  If all are culled, then the requested volume will also be
123 unmounted, otherwise error EBUSY will be returned.
125 This can be used by the administrator to attempt to unmount the whole AFS tree
168 Further cells can be added by commands similar to the following:
185 This should be compiled by:
194 and cell, eg: "afs@<cellname>".  This can be viewed with the keyctl program or
207 not acquired then all operations will be governed by the anonymous user parts
211 made by a possessor of that key will be secured with that key.
215 socket), then the operations on the file will be made with key that was used to