Lines Matching refs:you
9 allow you to change the timeout (default 5 seconds). Setting the
18 Depending on whether you have a DVB-S, DVB-C or DVB-T card, use
20 in ~/.[sct]zap/channels.conf. If you are lucky you can just copy
21 one of the supplied channel lists, or you can create a new one
22 by running apps/scan/scan. If you run scan on an unknown network
23 you might have to supply some start data in apps/scan/initial.h.
25 If you have a card with a built-in hardware MPEG-decoder the
27 you can use to watch TV with any v4l application. xawtv is known
28 to work. Note that you cannot change channels with xawtv, you
29 have to zap using [sct]zap. If you want a nice application for
32 If your card does not have a hardware MPEG decoder you need
103 If you are using a Technotrend/Hauppauge DVB-C card *without* analog
104 module, you might have to use module parameter adac=-1 (dvb-ttpci.o).
110 you have configured with the dvbnet utility. Check if there
111 are any packets with the IP addr and MAC addr you have
114 If tcpdump doesn't give you any output, check the statistics
116 dvb_net won't get any input; thus you have to run tcpdump
136 gives you access to the "analog" tv picture of the av7110 mpeg2
144 - dvb-core: DVB core module. This provides you with the