Lines Matching refs:point

15     1) Entry point for arch/arm
16     2) Entry point for arch/powerpc
17     3) Entry point for arch/x86
18     4) Entry point for arch/mips/bmips
128 point and the way a new platform should be added to the kernel. The
155 1) Entry point for arch/arm
158    There is one single entry point to the kernel, at the start
159    of the kernel image. That entry point supports two calling
194 2) Entry point for arch/powerpc
197    There is one single entry point to the kernel, at the start
198    of the kernel image. That entry point supports two calling
222         point is called by a) after the OF trampoline and can also be
230         PowerPC platform. The entry point definition then becomes:
272 3) Entry point for arch/x86
275   There is one single 32bit entry point to the kernel at code32_start,
276   the decompressor (the real mode entry point goes to the same  32bit
277   entry point once it switched into protected mode). That entry point
292 4) Entry point for arch/mips/bmips
295   Some bootloaders only support a single entry point, at the start of the
454      physical CPU ID is calling the kernel entry point. This is used,
458      point (see further chapters for more information on the required
586 discussed in a later chapter. At this point, it is only meant to give
697 entry point, there is no prom_init() pass, and thus you have to
1159 you can point to a property content and change it easily from whatever
1161 in some cells to "point" to a node (replaced by a phandle at compile
1180     like physical memory size or kernel arguments). At this point, 2