Lines Matching refs:be
4 - compatible : Should be "ti,omap4-musb" or "ti,omap3-musb"
5 - ti,hwmods : must be "usb_otg_hs"
6 - multipoint : Should be "1" indicating the musb controller supports
9 MUSB configuration-specific setting. Should be set to "16"
10 - ram-bits : Specifies the ram address size. Should be set to "12"
12 interface between the controller and the phy. It should be "0" or "1"
14 - mode : Should be "3" to represent OTG. "1" signifies HOST and "2"
16 - power : Should be "50". This signifies the controller can supply up to
47 - compatible : Should be
50 - ti,hwmods : Should be "usb_otg_ss"
54 - #address-cells, #size-cells : Must be present if the device has sub-nodes
56 It should be set to "1" for HW mode and "2" for SW mode.
65 The dwc3 core should be added as subnode to omap dwc3 glue.
67 The binding details of dwc3 can be found in: