Lines Matching refs:zone

38 			 the IC. See thermal zone binding for more details
106 get assigned to trip points of the zone. The cooling devices are expected
116   Type: phandle of	zone.
120 - contribution:		The cooling contribution to the thermal zone of the
123 			of all cooling contributions within a thermal zone.
131 * Thermal zone nodes
133 The thermal zone node is the node containing all the required info
134 for describing a thermal zone, including its cooling device bindings. The
135 thermal zone node must contain, apart from its own properties, one sub-node
136 containing trip nodes and one sub-node containing all the zone cooling maps.
140   Type: unsigned	when checking this thermal zone.
148   Type: list of 	used while monitoring the thermal zone.
153   Type: sub-node	required to describe the thermal zone.
172   Type: unsigned	thermal zone can dissipate at the desired
179 derivative over time) in two situations for a thermal zone:
181 (ii) - when the zone just needs to be monitored (polling-delay) or
193 The "thermal-zones" node is a container for all thermal zone nodes. It shall
195 "Thermal zone nodes". The "thermal-zones" node appears under "/".
202 (a) - CPU thermal zone
204 The CPU thermal zone example below describes how to setup one thermal zone
305 used to monitor the zone 'cpu-thermal' using its sole sensor. A fan
308 the thermal zone 'cpu-thermal' using its cooling states
312 linked to the same thermal zone, 'cpu-thermal', as a passive cooling device,
314 which is a trip point at 100C. On the thermal zone 'cpu-thermal', at the
348 			/* each zone within the SoC may have its own trips */
362 			/* each zone within the SoC may have its own cooling */
375 			/* each zone within the SoC may have its own trips */
389 			/* each zone within the SoC may have its own cooling */
402 			/* each zone within the SoC may have its own trips */
416 			/* each zone within the SoC may have its own cooling */
425 hotspots: one for CPU thermal zone, one for GPU thermal zone and the
426 other to monitor a DSP thermal zone.
432 monitor CPU thermal zone, <bandgap 1> is used to monitor GPU thermal
433 zone and <bandgap 2> is used to monitor DSP thermal zone. Each zone
438 (c) - Several sensors within one single thermal zone
441 one thermal zone.
509 The board thermal example below illustrates how to setup one thermal zone