Lines Matching refs:regulator

4 - regulator-name: A string used as a descriptive name for regulator outputs
5 - regulator-min-microvolt: smallest voltage consumers may set
6 - regulator-max-microvolt: largest voltage consumers may set
7 - regulator-microvolt-offset: Offset applied to voltages to compensate for voltage drops
8 - regulator-min-microamp: smallest current consumers may set
9 - regulator-max-microamp: largest current consumers may set
10 - regulator-input-current-limit-microamp: maximum input current regulator allows
11 - regulator-always-on: boolean, regulator should never be disabled
12 - regulator-boot-on: bootloader/firmware enabled regulator
13 - regulator-allow-bypass: allow the regulator to go into bypass mode
14 - regulator-allow-set-load: allow the regulator performance level to be configured
15 - <name>-supply: phandle to the parent supply/regulator node
16 - regulator-ramp-delay: ramp delay for regulator(in uV/uS)
18 initialised to zero (regulator-ramp-delay = <0>) for disabling ramp delay.
19 - regulator-enable-ramp-delay: The time taken, in microseconds, for the supply
22 required due to the combination of internal ramping of the regulator itself,
24 - regulator-soft-start: Enable soft start so that voltage ramps slowly
25 - regulator-state-mem sub-root node for Suspend-to-RAM mode
28 - regulator-state-disk sub-root node for Suspend-to-DISK mode
31 - regulator-state-[mem/disk] node has following common properties:
32 - regulator-on-in-suspend: regulator should be on in suspend state.
33 - regulator-off-in-suspend: regulator should be off in suspend state.
34 - regulator-suspend-microvolt: regulator should be set to this voltage
36 - regulator-mode: operating mode in the given suspend state.
38 every hardware so the valid modes are documented on each regulator
40 - regulator-initial-mode: initial operating mode. The set of possible operating
42 documentation explains which values the regulator supports.
43 - regulator-system-load: Load in uA present on regulator that is not captured by
45 - regulator-pull-down: Enable pull down resistor when the regulator is disabled.
46 - regulator-over-current-protection: Enable over current protection.
49 - regulator-compatible: If a regulator chip contains multiple
51 describes each regulator, then this property indicates which regulator
57 xyzreg: regulator@0 {
58 regulator-min-microvolt = <1000000>;
59 regulator-max-microvolt = <2500000>;
60 regulator-always-on;
63 regulator-state-mem {
64 regulator-on-in-suspend;
72 - <name>-supply: phandle to the regulator node
74 These are the same bindings that a regulator in the above
76 its just seen as a special case of a regulator being a
82 twl_reg1: regulator@0 {
88 twl_reg2: regulator@1 {