Lines Matching refs:of
7 describes the bindings for 'pmic' sub-block of max8997.
11 - reg: Specifies the i2c slave address of the pmic block. It should be 0x66.
13 - max8997,pmic-buck1-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
17 - max8997,pmic-buck2-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
21 - max8997,pmic-buck5-dvs-voltage: A set of 8 voltage values in micro-volt (uV)
25 [1] If none of the 'max8997,pmic-buck[1/2/5]-uses-gpio-dvs' optional
30 If either of the 'max8997,pmic-buck[1/2/5]-uses-gpio-dvs' optional
35 - interrupt-parent: Specifies the phandle of the interrupt controller to which
44 Additional properties required if either of the optional properties are used:
46 multiple bucks, changing the voltage value of one of the bucks may affect
47 that of another buck, which is the side effect of the change (set_voltage).
51 the possible 8 options selectable by the dvs gpios. The value of this
52 property should be between 0 and 7. If not specified or if out of range, the
53 default value of this property is set to 0.
56 for dvs. The format of the gpio specifier depends in the gpio controller.
58 Regulators: The regulators of max8997 that have to be instantiated should be
60 sub-node should be of the format as listed below.
66 The following are the names of the regulators that the max8997 pmic block
68 as per the datasheet of max8997.
85 - CHARGER_TOPOFF: end of charge current threshold level