Lines Matching refs:cell

127 When referencing the GPIO line from another node, the first cell must always
128 be zero and the second cell represents the gpio flags and described in the
135 When referencing the IRQ line from another node, the cell represents the
140 The PSCs should include a cell-index which is the index of the PSC in
141 hardware.  cell-index is used to determine which shared SoC registers to
142 use when setting up PSC clocking.  cell-index number starts at '0'.  ie:
143 	PSC1 has 'cell-index = <0>'
144 	PSC4 has 'cell-index = <3>'
154 #gpio-cells set to 2. First cell is the GPIO number which is interpreted
155 according to the bit numbers in the GPIO control registers. The second cell
166                     first cell specifies the speed in Mbps and the second