Lines Matching refs:in
9 - interrupt-parent: Should be the phandle for the interrupt controller. Use in
11 - interrupts: Interrupt mapping for GPIO IRQ (configure for both edges). Use in
13 - ti,battery-regulation-voltage: integer, maximum charging voltage in uV.
14 - ti,charge-current: integer, maximum charging current in uA.
15 - ti,termination-current: integer, charge will be terminated when current in
16 constant-voltage phase drops below this value (in uA).
25 (in uA). If this property is not specified, the input limit current is
29 - ti,ovp-voltage: Configures the over voltage protection voltage (in uV). If
31 - ti,in-dpm-voltage: Configures the threshold input voltage for the dynamic
32 power path management (in uV). If not specified a default of 4,360,000
63 ti,in-dpm-voltage = <4440000>;