Lines Matching refs:of
11 The PMIC sub-block contains a number of voltage and current regulators,
17 - compatible: Should be one of the following:
20 - reg: Specifies the i2c slave address of the pmic block. It should be 0x66.
23 - interrupt-parent: Specifies the phandle of the interrupt controller to which
29 for buck 1 dvs. The format of the gpio specifier depends on the gpio
32 for buck 2 dvs. The format of the gpio specifier depends on the gpio
35 the possible 4 options selectable by the dvs gpios. The value of this
36 property should be 0, 1, 2 or 3. If not specified or out of range,
37 a default value of 0 is taken.
39 the possible 2 options selectable by the dvs gpios. The value of this
40 property should be 0 or 1. If not specified or out of range, a default
41 value of 0 is taken.
42 - max8998,pmic-buck-voltage-lock: If present, disallows changing of
46 - max8998,pmic-buck1-dvs-voltage: An array of 4 voltage values in microvolts
50 - max8998,pmic-buck2-dvs-voltage: An array of 2 voltage values in microvolts
53 Regulators: All the regulators of MAX8998 to be instantiated shall be
55 by a child node of the 'regulators' node.
61 Following regulators of the MAX8998 PMIC block are supported. Note that