Lines Matching refs:you

18 at the lilo boot prompt (if you have a thinkpad):
32  If you give options both in the lilo config file and on the boot
41  If you use the floppy driver as a module, use the following syntax:
47  If you need certain options enabled every time you load the floppy driver,
48 you can put:
61 	Tells the floppy driver that you have a well behaved floppy controller.
70 	Tells the floppy driver that you have only one floppy controller.
75 	Tells the floppy driver that you have two floppy controllers.
78 	0x370, and if you use the 'cmos' option.
81 	Tells the floppy driver that you have a Thinkpad. Thinkpads use an
85 	Tells the floppy driver that you don't have a Thinkpad.
92 	if you frequently get "Unable to allocate DMA memory" messages.
96 	you have an FDC without a FIFO (8272A or 82072). 82072A and
98 	If you use nodma mode, I suggest you also set the FIFO
102 	If you have a FIFO-able FDC, the floppy driver automatically
104 	If you want to avoid this, explicitly ask for 'yesdma'.
111 	Disables the FIFO entirely. This is needed if you get "Bus
129 	disk. If you get a huge amount of "Over/Underrun - retrying"
131 	higher value, until you only get an occasional Over/Underrun.
135 	that you need to do 'floppycontrol --messages' every time you
143 	you have more than two floppy drives (only two can be
179 	cable, connection and jumper settings if you have any DCL
228  If you have a question or a bug report about the floppy driver, mail
229 me at Alain.Knaff@poboxes.com . If you post to Usenet, preferably use