Lines Matching refs:flash
6 Set the brightness of this LED in the flash strobe mode, in
7 microamperes. The file is created only for the flash LED devices
8 that support setting flash brightness.
18 Maximum brightness level for this LED in the flash strobe mode,
26 Hardware timeout for flash, in microseconds. The flash strobe
28 of the strobe. The file is created only for the flash LED
29 devices that support setting flash timeout.
36 Maximum flash timeout for this LED, in microseconds.
43 Flash strobe state. When written with 1 it triggers flash strobe
44 and when written with 0 it turns the flash off.
46 On read 1 means that flash is currently strobing and 0 means
47 that flash is off.
54 Space separated list of flash faults that may have occurred.
55 Flash faults are re-read after strobing the flash. Possible
56 flash faults:
58 * led-over-voltage - flash controller voltage to the flash LED
59 has exceeded the limit specific to the flash controller
60 * flash-timeout-exceeded - the flash strobe was still on when
61 the timeout set by the user has expired; not all flash
63 * controller-over-temperature - the flash controller has
66 of the flash controller has been triggered
68 supply has exceeded the limit specific to the flash
70 * indicator-led-fault - the flash controller has detected
72 * led-under-voltage - flash controller voltage to the flash
74 the flash
75 * controller-under-voltage - the input voltage of the flash
77 flash at full current will not be possible;