140 	unsigned char		ier;  member
304 	up->ier |= UART_IER_MSI;  in serial_omap_enable_ms()
305 	serial_out(up, UART_IER, up->ier);  in serial_omap_enable_ms()
352 	if (up->ier & UART_IER_THRI) {  in serial_omap_stop_tx()
353 		up->ier &= ~UART_IER_THRI;  in serial_omap_stop_tx()
354 		serial_out(up, UART_IER, up->ier);  in serial_omap_stop_tx()
365 		up->ier |= UART_IER_RLSI | UART_IER_RDI;  in serial_omap_stop_tx()
367 		serial_out(up, UART_IER, up->ier);  in serial_omap_stop_tx()
379 	up->ier &= ~(UART_IER_RLSI | UART_IER_RDI);  in serial_omap_stop_rx()
381 	serial_out(up, UART_IER, up->ier);  in serial_omap_stop_rx()
419 	if (!(up->ier & UART_IER_THRI)) {  in serial_omap_enable_ier_thri()
420 		up->ier |= UART_IER_THRI;  in serial_omap_enable_ier_thri()
421 		serial_out(up, UART_IER, up->ier);  in serial_omap_enable_ier_thri()
463 	up->ier &= ~(UART_IER_RLSI | UART_IER_RDI);  in serial_omap_throttle()
464 	serial_out(up, UART_IER, up->ier);  in serial_omap_throttle()
477 	up->ier |= UART_IER_RLSI | UART_IER_RDI;  in serial_omap_unthrottle()
478 	serial_out(up, UART_IER, up->ier);  in serial_omap_unthrottle()
494 	if (status & UART_MSR_ANY_DELTA && up->ier & UART_IER_MSI &&  in check_modem_status()
798 	up->ier = UART_IER_RLSI | UART_IER_RDI;  in serial_omap_startup()
799 	serial_out(up, UART_IER, up->ier);  in serial_omap_startup()
825 	up->ier = 0;  in serial_omap_shutdown()
956 	up->ier &= ~UART_IER_MSI;  in serial_omap_set_termios()
958 		up->ier |= UART_IER_MSI;  in serial_omap_set_termios()
959 	serial_out(up, UART_IER, up->ier);  in serial_omap_set_termios()
1035 	serial_out(up, UART_IER, up->ier);  in serial_omap_set_termios()
1280 	unsigned int ier;  in serial_omap_console_write()  local
1296 	ier = serial_in(up, UART_IER);  in serial_omap_console_write()
1306 	serial_out(up, UART_IER, ier);  in serial_omap_console_write()
1380 	mode = up->ier;  in serial_omap_config_rs485()
1381 	up->ier = 0;  in serial_omap_config_rs485()
1405 	up->ier = mode;  in serial_omap_config_rs485()
1406 	serial_out(up, UART_IER, up->ier);  in serial_omap_config_rs485()
1812 	serial_out(up, UART_IER, up->ier);  in serial_omap_restore_context()