Lines Matching refs:us
93 /* Has the driver posted any work for us? */
209 /* Initiator that selected us */
232 * in talking to us. Go directly to bus free.
233 * XXX SCSI-1 may require us to assume lun 0 if
411 * We carefully toggle SPIOEN to allow us to return the
475 * Now determine what phases the host wants us
690 * We assume that the kernel driver may reset us
842 * the host driver to fix us up based on the transfer residual.
890 * us to another phase, and then notify the host.
957 * allows us to update our notion of where we are
964 * another segment. This will allow us to immediately
987 * feature of the chip allows us to load two elements
1256 * If the target has left us in data phase, loop through
1478 * control byte. This will cause us to interrupt the host and allow
1488 * BDR message in response to a bad reselection would leave us pointed to
1495 * in case the target decides to put us in this phase for some strange
1610 * it to the QINFIFO and tell us not to post to the QOUTFIFO by setting
1618 * Either way, the target should take us to message out phase
1635 * to mesgin to give an invalid message, let the host abort us.
1648 * See if we attempted to deliver a message but the target ingnored us.
1693 * Is it a disconnect message? Set a flag in the SCB to remind us
1703 * should take us to message out phase and then attempt to
1740 * transfer, just mark us at the end rather than perform a
1804 * Identify message? For a reconnecting target, this tells us the lun