67 	if (skb->len < dev->net->hard_header_len)  in sr_rx_fixup()
79 			netdev_err(dev->net, "%s : Bad Header Length\n",  in sr_rx_fixup()
84 		if ((size > dev->net->mtu + ETH_HLEN + VLAN_HLEN) ||  in sr_rx_fixup()
86 			netdev_err(dev->net, "%s : Bad RX Length %d\n",  in sr_rx_fixup()
90 		sr_skb = netdev_alloc_skb_ip_align(dev->net, size);  in sr_rx_fixup()
102 		netdev_err(dev->net, "%s : Bad SKB Length %d\n", __func__,  in sr_rx_fixup()
161 	if (netif_carrier_ok(dev->net) != link) {  in sr_status()
163 		netdev_dbg(dev->net, "Link Status is: %d\n", link);  in sr_status()
175 		netdev_err(dev->net, "Failed to enable software MII access\n");  in sr_set_sw_mii()
185 		netdev_err(dev->net, "Failed to enable hardware MII access\n");  in sr_set_hw_mii()
196 		netdev_err(dev->net, "%s : Error reading PHYID register:%02x\n",  in sr_get_phy_addr()
200 	netdev_dbg(dev->net, "%s : returning 0x%04x\n", __func__,  in sr_get_phy_addr()
215 		netdev_err(dev->net, "Failed to send software reset:%02x\n",  in sr_sw_reset()
228 		netdev_err(dev->net, "Error reading RX_CTL register:%02x\n",  in sr_read_rx_ctl()
242 	netdev_dbg(dev->net, "%s : mode = 0x%04x\n", __func__, mode);  in sr_write_rx_ctl()
245 		netdev_err(dev->net,  in sr_write_rx_ctl()
259 		netdev_err(dev->net,  in sr_read_medium_status()
271 	netdev_dbg(dev->net, "%s : mode = 0x%04x\n", __func__, mode);  in sr_write_medium_mode()
274 		netdev_err(dev->net,  in sr_write_medium_mode()
284 	netdev_dbg(dev->net, "%s : value = 0x%04x\n", __func__, value);  in sr_write_gpio()
287 		netdev_err(dev->net, "Failed to write GPIO value 0x%04x:%02x\n",  in sr_write_gpio()
296 static void sr_set_multicast(struct net_device *net)  in sr_set_multicast()  argument
298 	struct usbnet *dev = netdev_priv(net);  in sr_set_multicast()
302 	if (net->flags & IFF_PROMISC) {  in sr_set_multicast()
304 	} else if (net->flags & IFF_ALLMULTI ||  in sr_set_multicast()
305 		   netdev_mc_count(net) > SR_MAX_MCAST) {  in sr_set_multicast()
307 	} else if (netdev_mc_empty(net)) {  in sr_set_multicast()
321 		netdev_for_each_mc_addr(ha, net) {  in sr_set_multicast()
336 static int sr_mdio_read(struct net_device *net, int phy_id, int loc)  in sr_mdio_read()  argument
338 	struct usbnet *dev = netdev_priv(net);  in sr_mdio_read()
347 	netdev_dbg(dev->net,  in sr_mdio_read()
355 sr_mdio_write(struct net_device *net, int phy_id, int loc, int val)  in sr_mdio_write()  argument
357 	struct usbnet *dev = netdev_priv(net);  in sr_mdio_write()
360 	netdev_dbg(dev->net,  in sr_mdio_write()
379 		phy_reg = sr_mdio_read(dev->net, dev->mii.phy_id, MII_PHYSID1);  in sr_get_phyid()
390 	phy_reg = sr_mdio_read(dev->net, dev->mii.phy_id, MII_PHYSID2);  in sr_get_phyid()
400 sr_get_wol(struct net_device *net, struct ethtool_wolinfo *wolinfo)  in sr_get_wol()  argument
402 	struct usbnet *dev = netdev_priv(net);  in sr_get_wol()
419 sr_set_wol(struct net_device *net, struct ethtool_wolinfo *wolinfo)  in sr_set_wol()  argument
421 	struct usbnet *dev = netdev_priv(net);  in sr_set_wol()
436 static int sr_get_eeprom_len(struct net_device *net)  in sr_get_eeprom_len()  argument
438 	struct usbnet *dev = netdev_priv(net);  in sr_get_eeprom_len()
444 static int sr_get_eeprom(struct net_device *net,  in sr_get_eeprom()  argument
447 	struct usbnet *dev = netdev_priv(net);  in sr_get_eeprom()
470 static void sr_get_drvinfo(struct net_device *net,  in sr_get_drvinfo()  argument
473 	struct usbnet *dev = netdev_priv(net);  in sr_get_drvinfo()
477 	usbnet_get_drvinfo(net, info);  in sr_get_drvinfo()
483 static u32 sr_get_link(struct net_device *net)  in sr_get_link()  argument
485 	struct usbnet *dev = netdev_priv(net);  in sr_get_link()
490 static int sr_ioctl(struct net_device *net, struct ifreq *rq, int cmd)  in sr_ioctl()  argument
492 	struct usbnet *dev = netdev_priv(net);  in sr_ioctl()
497 static int sr_set_mac_address(struct net_device *net, void *p)  in sr_set_mac_address()  argument
499 	struct usbnet *dev = netdev_priv(net);  in sr_set_mac_address()
503 	if (netif_running(net))  in sr_set_mac_address()
508 	memcpy(net->dev_addr, addr->sa_data, ETH_ALEN);  in sr_set_mac_address()
551 	netdev_dbg(dev->net, "%s : speed: %u duplex: %d mode: 0x%04x\n",  in sr9800_link_reset()
565 	sr_mdio_write(dev->net, dev->mii.phy_id, MII_BMCR, BMCR_RESET);  in sr9800_set_default_mode()
566 	sr_mdio_write(dev->net, dev->mii.phy_id, MII_ADVERTISE,  in sr9800_set_default_mode()
578 		netdev_dbg(dev->net, "Write IPG,IPG1,IPG2 failed: %d\n", ret);  in sr9800_set_default_mode()
588 	netdev_dbg(dev->net, "RX_CTL is 0x%04x after all initializations\n",  in sr9800_set_default_mode()
592 	netdev_dbg(dev->net, "Medium Status:0x%04x after all initializations\n",  in sr9800_set_default_mode()
615 		netdev_dbg(dev->net, "Select PHY #1 failed: %d\n", ret);  in sr9800_reset()
643 	netdev_dbg(dev->net, "RX_CTL is 0x%04x after software reset\n", rx_ctl);  in sr9800_reset()
649 	netdev_dbg(dev->net, "RX_CTL is 0x%04x setting to 0x0000\n", rx_ctl);  in sr9800_reset()
668 	memcpy(data->mac_addr, dev->net->dev_addr, ETH_ALEN);  in sr9800_reset()
699 		netdev_err(dev->net, "Failed to power down PHY : %d\n", ret);  in sr9800_phy_powerup()
707 		netdev_err(dev->net, "Failed to reset PHY: %d\n", ret);  in sr9800_phy_powerup()
715 		netdev_err(dev->net, "Failed to power up PHY: %d\n", ret);  in sr9800_phy_powerup()
723 		netdev_err(dev->net, "Failed to reset PHY: %d\n", ret);  in sr9800_phy_powerup()
753 			netdev_err(dev->net, "set LINK LED failed : %d\n", ret);  in sr9800_bind()
759 			  dev->net->dev_addr);  in sr9800_bind()
761 		netdev_dbg(dev->net, "Failed to read MAC address: %d\n", ret);  in sr9800_bind()
764 	netdev_dbg(dev->net, "mac addr : %pM\n", dev->net->dev_addr);  in sr9800_bind()
767 	dev->mii.dev = dev->net;  in sr9800_bind()
774 	dev->net->netdev_ops = &sr9800_netdev_ops;  in sr9800_bind()
775 	dev->net->ethtool_ops = &sr9800_ethtool_ops;  in sr9800_bind()
781 		netdev_dbg(dev->net, "Select PHY #1 failed: %d\n", ret);  in sr9800_bind()
791 	netdev_dbg(dev->net, "RX_CTL is 0x%04x after software reset\n", rx_ctl);  in sr9800_bind()
797 	netdev_dbg(dev->net, "RX_CTL is 0x%04x setting to 0x0000\n", rx_ctl);  in sr9800_bind()
801 	netdev_dbg(dev->net, "PHYID=0x%08x\n", phyid);  in sr9800_bind()
814 			netdev_err(dev->net, "Reset RX_CTL failed: %d\n", ret);  in sr9800_bind()
825 			netdev_err(dev->net, "Reset RX_CTL failed: %d\n", ret);  in sr9800_bind()
831 	netdev_dbg(dev->net, "%s : setting rx_urb_size with : %zu\n", __func__,  in sr9800_bind()