659 		SMSC_TRACE(pdata, hw, "Forcing internal PHY");  in smsc911x_phy_initialise_external()
662 		SMSC_TRACE(pdata, hw, "Forcing external PHY");  in smsc911x_phy_initialise_external()
666 		SMSC_TRACE(pdata, hw,  in smsc911x_phy_initialise_external()
671 		SMSC_TRACE(pdata, hw,  in smsc911x_phy_initialise_external()
795 				SMSC_TRACE(pdata, hw, "Successfully verified "  in smsc911x_phy_check_loopbackpkt()
817 	SMSC_TRACE(pdata, hw, "Performing PHY BCR Reset");  in smsc911x_phy_reset()
930 		SMSC_TRACE(pdata, hw, "rx pause %s, tx pause %s",  in smsc911x_phy_update_flowcontrol()
934 		SMSC_TRACE(pdata, hw, "half duplex");  in smsc911x_phy_update_flowcontrol()
957 		SMSC_TRACE(pdata, hw, "duplex state has changed");  in smsc911x_phy_adjust_link()
962 			SMSC_TRACE(pdata, hw,  in smsc911x_phy_adjust_link()
966 			SMSC_TRACE(pdata, hw,  in smsc911x_phy_adjust_link()
979 		SMSC_TRACE(pdata, hw, "carrier state has changed");  in smsc911x_phy_adjust_link()
981 			SMSC_TRACE(pdata, hw, "configuring for carrier OK");  in smsc911x_phy_adjust_link()
990 			SMSC_TRACE(pdata, hw, "configuring for no carrier");  in smsc911x_phy_adjust_link()
1026 	SMSC_TRACE(pdata, probe, "PHY: addr %d, phy_id 0x%08X",  in smsc911x_mii_probe()
1055 	SMSC_TRACE(pdata, hw, "Passed Loop Back Test");  in smsc911x_mii_probe()
1058 	SMSC_TRACE(pdata, hw, "phy initialised successfully");  in smsc911x_mii_probe()
1095 		SMSC_TRACE(pdata, hw, "External PHY is not supported, "  in smsc911x_mii_init()
1313 	SMSC_TRACE(pdata, hw, "maccr 0x%08X, HASHH 0x%08X, HASHL 0x%08X",  in smsc911x_rx_multicast_update()
1573 		SMSC_TRACE(pdata, ifup, "irq polarity: active high");  in smsc911x_open()
1576 		SMSC_TRACE(pdata, ifup, "irq polarity: active low");  in smsc911x_open()
1580 		SMSC_TRACE(pdata, ifup, "irq type: push-pull");  in smsc911x_open()
1583 		SMSC_TRACE(pdata, ifup, "irq type: open drain");  in smsc911x_open()
1588 	SMSC_TRACE(pdata, ifup, "Testing irq handler using IRQ %d", dev->irq);  in smsc911x_open()
1608 	SMSC_TRACE(pdata, ifup, "IRQ handler passed test using IRQ %d",  in smsc911x_open()
1677 	SMSC_TRACE(pdata, ifdown, "Interface stopped");  in smsc911x_stop()
1797 			SMSC_TRACE(pdata, hw, "scheduling mcast update");  in smsc911x_set_multicast_list()
1839 		SMSC_TRACE(pdata, intr, "RX Stop interrupt");  in smsc911x_irqhandler()
1856 		SMSC_TRACE(pdata, intr, "RX Error interrupt");  in smsc911x_irqhandler()
2013 	SMSC_TRACE(pdata, drv, "op 0x%08x", op);  in smsc911x_eeprom_send_cmd()
2028 		SMSC_TRACE(pdata, drv, "TIMED OUT");  in smsc911x_eeprom_send_cmd()
2033 		SMSC_TRACE(pdata, drv, "Error occurred during eeprom operation");  in smsc911x_eeprom_send_cmd()
2046 	SMSC_TRACE(pdata, drv, "address 0x%x", address);  in smsc911x_eeprom_read_location()
2062 	SMSC_TRACE(pdata, drv, "address 0x%x, data 0x%x", address, data);  in smsc911x_eeprom_write_location()
2177 	SMSC_TRACE(pdata, probe, "Driver Parameters:");  in smsc911x_init()
2178 	SMSC_TRACE(pdata, probe, "LAN base: 0x%08lX",  in smsc911x_init()
2180 	SMSC_TRACE(pdata, probe, "IRQ: %d", dev->irq);  in smsc911x_init()
2181 	SMSC_TRACE(pdata, probe, "PHY will be autodetected.");  in smsc911x_init()
2217 	SMSC_TRACE(pdata, probe, "BYTE_TEST: 0x%08X", byte_test);  in smsc911x_init()
2219 		SMSC_TRACE(pdata, probe, "BYTE_TEST looks swapped, "  in smsc911x_init()
2235 			SMSC_TRACE(pdata, probe,  in smsc911x_init()
2278 	SMSC_TRACE(pdata, probe,  in smsc911x_init()
2320 	SMSC_TRACE(pdata, ifdown, "Stopping driver");  in smsc911x_drv_remove()
2533 		SMSC_TRACE(pdata, probe,  in smsc911x_drv_probe()
2548 		SMSC_TRACE(pdata, probe,  in smsc911x_drv_probe()
2552 		SMSC_TRACE(pdata, probe,  in smsc911x_drv_probe()
2561 			SMSC_TRACE(pdata, probe,  in smsc911x_drv_probe()
2567 			SMSC_TRACE(pdata, probe,  in smsc911x_drv_probe()