91 		pr_err("no proper response during fw download");  in validate_firmware_response()
92 		pr_err("data6 %x", skb->data[5]);  in validate_firmware_response()
116 		pr_err("Data length is too large len %d room %d", len,  in kim_check_data_len()
154 		pr_err(" received null from TTY ");  in kim_int_recv()
205 			pr_err("can't allocate mem for new packet");  in kim_int_recv()
228 		pr_err("kim: couldn't write 4 bytes");  in read_local_version()
235 		pr_err(" waiting for ver info- timed out or received signal");  in read_local_version()
275 		pr_err("invalid action after change remote baud command");  in skip_change_remote_baud()
304 		pr_err("kim: failed to read local ver");  in download_firmware()
312 		pr_err(" request_firmware failed(errno %ld) for %s", err,  in download_firmware()
353 					pr_err("Unable to get free "  in download_firmware()
364 				pr_err("Timeout while waiting for free "  in download_firmware()
391 				pr_err("Number of bytes written to uart "  in download_firmware()
404 				pr_err("response timeout/signaled during fw download ");  in download_firmware()
502 			pr_err("ldisc installation timeout");  in st_kim_start()
512 				pr_err("download firmware failed");  in st_kim_start()
564 		pr_err(" timed out waiting for ldisc to be un-installed");  in st_kim_stop()
757 		pr_err("Can't allocate device_tree platform data\n");  in get_platform_data()
797 		pr_err("no mem to allocate");  in kim_probe()
804 		pr_err(" ST core init failed");  in kim_probe()
815 		pr_err(" gpio %d request failed ", kim_gdata->nshutdown);  in kim_probe()
822 		pr_err(" unable to configure gpio %d", kim_gdata->nshutdown);  in kim_probe()
833 		pr_err("failed to create sysfs entries");  in kim_probe()
845 		pr_err(" debugfs entries creation failed ");  in kim_probe()