158 		dev_err(&client->dev, "i2c send data request error: %d\n", ret);  in zforce_command()
172 		dev_err(&client->dev, "already waiting for a command\n");  in zforce_send_wait()
185 		dev_err(&client->dev, "i2c send data request error: %d\n", ret);  in zforce_send_wait()
217 		dev_err(&client->dev, "i2c send data request error: %d\n", ret);  in zforce_command_wait()
273 		dev_err(&client->dev, "Unable to initialize, %d\n", ret);  in zforce_start()
279 		dev_err(&client->dev, "Unable to set resolution, %d\n", ret);  in zforce_start()
285 		dev_err(&client->dev, "Unable to set scan frequency, %d\n",  in zforce_start()
292 		dev_err(&client->dev, "Unable to set config\n");  in zforce_start()
299 		dev_err(&client->dev, "Unable to request data\n");  in zforce_start()
326 		dev_err(&client->dev, "could not deactivate device, %d\n",  in zforce_stop()
423 		dev_err(&client->dev, "error reading header: %d\n", ret);  in zforce_read_packet()
428 		dev_err(&client->dev, "invalid frame start: %d\n", buf[0]);  in zforce_read_packet()
434 		dev_err(&client->dev, "invalid payload length: %d\n",  in zforce_read_packet()
443 		dev_err(&client->dev, "error reading payload: %d\n", ret);  in zforce_read_packet()
506 			dev_err(&client->dev,  in zforce_irq_thread()
560 			dev_err(&ts->client->dev, "invalid command: 0x%x\n",  in zforce_irq_thread()
565 			dev_err(&ts->client->dev,  in zforce_irq_thread()
712 		dev_err(dev, "failed to allocate platform data\n");  in zforce_parse_dt()
718 		dev_err(dev, "failed to get interrupt gpio\n");  in zforce_parse_dt()
724 		dev_err(dev, "failed to get reset gpio\n");  in zforce_parse_dt()
729 		dev_err(dev, "failed to get x-size property\n");  in zforce_parse_dt()
734 		dev_err(dev, "failed to get y-size property\n");  in zforce_parse_dt()
762 		dev_err(&client->dev, "request of gpio %d failed, %d\n",  in zforce_probe()
770 		dev_err(&client->dev, "request of gpio %d failed, %d\n",  in zforce_probe()
794 		dev_err(&client->dev, "failed to register reset action, %d\n",  in zforce_probe()
809 		dev_err(&client->dev, "could not allocate input device\n");  in zforce_probe()
860 		dev_err(&client->dev, "irq %d request failed\n", client->irq);  in zforce_probe()
876 		dev_err(&client->dev, "unable to initialize, %d\n", ret);  in zforce_probe()
883 		dev_err(&client->dev, "couldn't get status, %d\n", ret);  in zforce_probe()
897 		dev_err(&client->dev, "could not register input device, %d\n",  in zforce_probe()