293 	dev_err(&dev->pdev->dev,  in stu300_event_occurred()
350 		dev_err(&dev->pdev->dev,  in stu300_start_and_await_event()
357 		dev_err(&dev->pdev->dev, "controller timed out "  in stu300_start_and_await_event()
364 		dev_err(&dev->pdev->dev, "controller (start) "  in stu300_start_and_await_event()
385 		dev_err(&dev->pdev->dev, "irqs are disabled on this "  in stu300_await_event()
406 		dev_err(&dev->pdev->dev,  in stu300_await_event()
414 			dev_err(&dev->pdev->dev, "controller "  in stu300_await_event()
424 			dev_err(&dev->pdev->dev, "controller "  in stu300_await_event()
455 		dev_err(&dev->pdev->dev, "transaction timed out "  in stu300_wait_while_busy()
459 		dev_err(&dev->pdev->dev, "base address = "  in stu300_wait_while_busy()
465 	dev_err(&dev->pdev->dev, "giving up after %d attempts "  in stu300_wait_while_busy()
502 		dev_err(&dev->pdev->dev, "too %s clock rate requested "  in stu300_set_clk()
522 		dev_err(&dev->pdev->dev, "too low clock rate (%lu Hz).\n",  in stu300_set_clk()
529 		dev_err(&dev->pdev->dev, "too high clock rate (%lu Hz).\n",  in stu300_set_clk()
778 				dev_err(&dev->pdev->dev, "error awaiting "  in stu300_xfer_msg()
787 				dev_err(&dev->pdev->dev, "I2C payload "  in stu300_xfer_msg()
804 		dev_err(&dev->pdev->dev, "timeout waiting for transfer "  in stu300_xfer_msg()
877 		dev_err(&pdev->dev, "could not retrieve i2c bus clock\n");  in stu300_probe()
900 		dev_err(&dev->pdev->dev, "error initializing hardware.\n");  in stu300_probe()
924 		dev_err(&pdev->dev, "failure adding ST Micro DDC "  in stu300_probe()
956 		dev_err(device, "error re-initializing hardware.\n");  in stu300_resume()