Lines Matching refs:or

11      * Linux installation with Linux kernel 2.6.22 or newer (if building
13      * Intel i2400m Echo Peak or Baxter Peak; this includes the Intel
21             linux-dev-VERSION or linux-headers-VERSION).
32    If USB or SDIO are not enabled in the kernel configuration, the options
33    to build the i2400m USB or SDIO drivers will not show. Enable said
55    directory or if you want to build for a kernel that is not the
64    The firmware can be obtained from http://linuxwimax.org or might have
71      * NOTE: if your firmware came in an .rpm or .deb file, just install
72        it as normal, with the rpm (rpm -i FIRMWARE.rpm) or dpkg
74      * BUSTYPE will be usb or sdio, depending on the hardware you have.
109    and output messages in the kernel log (dmesg, /var/log/messages or
124    Module parameters can be set at kernel or module load time or by
147    reinitialized by the driver (eg: following a reset or a reconnect).
159      * /sys/kernel/debug/wimax:DEVNAME/i2400m-usb (or -sdio) for the
160        bus-specific i2400m-usb or i2400m-sdio controls).
239    By writing a 0, a 1 or a 2 to the file
241    disconnecting from the bus), cold (disconnecting from the bus) or bus